The Musotoku power supply will keep your rotary or coil machines running smoothly all day long. The high output (5A) will give you a clean and stable current, so your tattoo machines will run without any fluctuations and they will stay cool even if you run them for long periods. The voltage can be adjusted from 2 to 16 volt in 0.1V steps, letting you control the hit of your machine with precision. If you need a bit of extra power to start your machine up, you can turn on the Nitro function. This will give you an extra boost for the first 0.5 seconds, so you can start even the heaviest motors or machines running on a low voltage. The Musotoku also has no less than three overcurrent protection systems, so it will cut out if there is a problem with either your machine or your cables. This will protect your coil or rotary machines and extend their lifetime.
The Musotoku is easy to operate: Changing the voltage, or storing and accessing your preferred settings can all be done with a single button. It also offers three different modes: you can either keep your pedal down to keep your machine running, use the pedal with the ON/OFF mode or go without using a pedal at all with the maintained mode which let you turn your machine on or off on the power supply. The Musotoku has a special electronic sensor which filters out any micro-interruptions, so your machine will keep running smoothly even if the contacts on your foot switch are a bit rusty or dirty.
The Musotoku is made out of aircraft grade aluminium and weighs only 169 gram. It measures just 11.6cm by 7.2cm and comes with a protective travel case, so it is perfect for conventions and small work areas. The rubber band at the top of the power supply keeps the power lead out of the way. It can be mounted on the Musotoku arm clamp, GoPro attachments or tripods with a 1/4" screw.